Simatic Process Device Manager (Pdm); Maintenance Settings (Accessible Via Pdm Only) - Siemens SITRANS Probe LU Operating Instructions Manual

Chart 4
Output param
1. Analog output
2. Apply values
3. Local Display
4. HART output

SIMATIC Process Device Manager (PDM):

This software package is designed to permit easy configuration, monitoring and
troubleshooting of HART devices. The HART DD for the SITRANS Probe LU was written
with SIMATIC PDM in mind and has been extensively tested with this software.
The Device Description for SIMATIC PDM may be downloaded from the product page of
our website at: https://pia.khe.siemens.com/index.asp?Nr=11157, under Downloads.
All parameters accessible via the HART Communicator are also accessible via PDM. In
addition, the Maintenance parameters listed below are accessible via PDM only.

Maintenance settings (accessible via PDM only)

Device Lifetime
Total Device Operating Time
Remaining Device Lifetime
Maintenance Required Limit
Maintenance Demanded Limit
Maintenance Alert Activation
Total Expected Device Life
Units
Maintenance Status
Acknowledge Status
Acknowledge
A5E32337695 SITRANS Probe LU (HART) – OPERATING INSTRUCTIONS
Apply values
1. 4 mA
2. 20 mA
3. Exit
Analog Output
1. Read Analog Out
2. mA Function
3. FS default measure
4. Min mA
5. Max mA
6. Low Setpoint
7. High Setpoint
Local Display
1. Write protect
2. Lock
3. Write Protect
4. unlock value
HART Output
1. Poll addr
2. Num req preams
3. Num resp preams
FS default measurement
hold
hold
high
low
select
Page 79