Specifications; Printer - SATO WS408DT Operator's Manual

11 Specifications

11 Specifications

11.1 Printer

Model
Print method
Resolution
Media
Alignment
Operation Mode Standard: Continuous, Tear-off
Sensors
Print Speed
Print Darkness
Max Printable
Area
Non-Printable
Area
Interface
Optional
Interface
On-Board
Memory
Direct Thermal and Thermal Transfer
203 dpi (8 dots/mm)
Centre Alignment
DT: Gap Sensor (Transmissive, fixed)
TT: Gap sensor(Transmissive, fixed) Offset:
Media Sensor
6.27mm - Factory Default Sensor
I-Mark Sensor (Reflective, Movable)
WS408: 2, 3, 4, 5, 6 ins/sec (50.8, 76.2, 101.6, 127, 152.4mm/s)
WS412: 2, 3, 4 ins/sec (50.8, 76.2, 101.6mm/s)
2 &3 ips for dispenser mode
Do not set Print Speed to 4 ips or higher speed, when the
peeler module is installed and the peeler cover is open.
Darkness level –SBPL: 1 ~ 5
Default – DT: SBPL 3
Length 999 mm x Width 104 mm
Pitch Direction - Top: 1.5 mm, Bottom: 1.5 mm (excluding liner)
Width Direction - Left: 1.5 mm, Right: 1.5 mm (excluding liner)
STANDARD Model: USB (Type A and Type B), Ethernet, RS232C
LAN Model: USB (Type A and Type B), Ethernet
Bluetooth, Wireless LAN
Standard Memory (Flash ROM): 16 MB
User Memory: 2 MB
WS4DT and WS4TT
300 dpi (12 dots/mm)
Head Open Switch
Ribbon Sensor
TT: SBPL 3
WS4-DT/TT-r01-12.1.17-OM-RS
72
Printer