Jet JWL-1221VS Assembly Instructions And Parts List

Stand Extension for JWL-1221VS Lathe
Read and understand the entire owner's manual that accompanied your JWL-1221VS
lathe before attempting assembly or operation of accessories.
Inspect contents for shipping damage. Report any damage or part shortages to your distributor. Do not discard
shipping materials until accessory is set up and functioning properly.
Shipping contents
1 Cross bar
1 Tube
1 Bracket
2 Socket head button screws, 5/16x1
4 Socket head button screws, 5/16x1/2
4 Lock washers, 5/16"
6 Flat washers, 5/16"
1 Leveling pad with nut
2 Socket head cap screws, 5/16x1
Tools required for assembly
5mm and 6mm hex keys ("Allen wrenches")
Adjustable wrench
Assembly
(Parts in brackets refer to index numbers in the
exploded view. Refer to document M-719201 for
JET
427 New Sanford Road
LaVergne, Tennessee 37086
Ph.: 800-274-6848
www.jettools.com
Assembly Instructions and Parts List
Stock No. 719203
instructions on assembling optional Bed Extension
to lathe).
1. If not already mounted, screw leveling pad with
nut [4/3] into bottom of tube [2]. The leveling
pad can be adjusted for height, and the nut
tightened up against the tube to secure the
setting.
2. Remove the right leg from your lathe.
WARNING: Use an assistant or block up the
lathe to support it during these procedures!
3. Install the leg just removed to the end of the
bed extension.
4. Install the middle leg beneath center of lathe
with two 5/16x1-1/4 hex cap screws [8], lock
washers [6], and flat washers [7]. Secure tool
tray and cross bar to this middle leg.
5. Install new cross bar [9] between legs with four
5/16x1/2 socket head button screws [5] and
flat washers [7] and tighten.
Part No. M-719203
Revision A1 02/2014
Copyright © 2014 JET