Advertisement
Please do not use undesignated battery to the device.
Please do not dismantle and destroy the battery without permission; water is not allowed to
enter the device; man-made damages are not covered by warranty.
Please do not throw the battery into fire or expose it to high-temperature environment.
Please do not dismantle, modify or deform the battery.
Avoid short circuit between positive and negative contacts (please do not place the battery
together with the objects such as necklace and hairpin etc. when carrying or storing the
battery).
Please replace new battery timely when it is damaged. Please contact local relevant
agency to deal with damaged battery properly, in order to prevent accidents.
Please charge the battery or discharge it to 50%～60% remaining capacity if it won't be
used for a long time, and place it in a dry and cool environment.
For air transport, according to relevant aviation requirement, please discharge aircraft
battery and remote control battery to below 30%.
If the battery leaks and the liquid enters eyes accidentally, please do not rub your eyes;
wash your eyes with clean water and see a doctor immediately.
It is normal that the battery heats up after it is running for a period of time, because the
discharge power is quite big.
It is normal that the battery heats up when it is being charged.
The cycle times of aircraft power battery is 300 in normal application situation.
During charging of power battery, charging is completed when the charger displays "FULL"
and beeps continuously. Don't take down batteries before charging is completed.
Application Environment Requirements
Please do not aim the PTZ camera at strong light (such as lighting, sunlight and so on).
Please transport, use and store the device within the allowed humidity and temperature
range.
Please do not let any liquid flow into the device.
Please do not block the device ventilation.
Please do not press, vibrate or soak the device.
Please pack the device with original package or material with equivalent quality.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Caution: The user is cautioned that changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
VII
Advertisement
