Advertisement
Step 8
After charging is completed, disconnect it from the power socket, and then disconnect
all other cables.
1.8.2 Remote Control Charging
The entire charging period (from 0 to full) needs approximately 3.5 hours.
Please charge the remote control when its power is off.
Step 1
Connect DC: connect the remote control and power adapter with a charging cable.
Step 2
Connect AC: connect power adapter with AC power (AC 100V- AC 240V).
Step 3
Check charging state: it means the remote control is charging when the indicator light is
red and normally on. It means charging is done when the indicator light becomes
yellow-green and normally on, as shown in Figure 0-8.
Step 4
Disconnect it from the power socket, and then disconnect other cables after charging is
completed.
1.9
Prepare Airborne Device
The following chapter is optional for operation. It is for your reference when airborne device
shall be replaced.
This chapter introduces operation of airborne device with PTZ camera as an example.
Please refer to actual product.
Figure 0-6
Figure 0-7
Figure 0-8
30
Advertisement
