Table of Contents
Advertisement
Selecting system priority [F85]
If you leave the service area of a carrier from which the phone is currently receiving
signals, the phone automatically starts searching for another carrier. You can control
the order in which the phone searches for a carrier.
1
Turn
to select Set System from the Network menu, then push
The Set System menu appears.
2
Turn
to set the preferences.
You can select standard, home side, roam side, or home only. If you select
standard, the phone searches for the system to which you subscribe first,
then searches for an alternate system. If you select home side, the phone
searches for the system to which you subscribe in all regions of coverage. If
you select roam side, the phone searches only for an alternate system. If you
select home only, the phone searches for the system to which you subscribe
only in your home region.
3
Push
to enter the new setting.
The standby display reappears.
Forcing the phone into analog mode [F86]
You can force the phone into analog mode for the next outgoing or incoming call.
1
Turn
to select Force Call from the Network menu, then push
The Force Call menu appears.
2
Press
to force the phone into analog mode, or push
1
digital mode.
After a few seconds, the standby display reappears. Your phone stays in
analog mode for 10 minutes, or until you terminate the call or turn off the
phone.
Note
Your phone generally stays in digital mode as long as digital service signals are received.
The phone switches to analog mode when an analog service but no digital service is
available, even if you do not perform the procedure above.
5.3_CM_Z200
27
.
.
to stay in
5.27
6/8/98, 9:28 AM
Advertisement
Table of Contents
