Led On Charger; Connecting The Water Supply; Switching On - Stihl TSA 230 Instruction Manual

English

LED on Charger

1
The LED (1) on the charger may glow
continuously green or flash red.
Green continuous light ...
... indicates the following:
The battery
is being charged
–
is too hot and must cool down
–
before charging
See also "LEDs on battery".
The green LED on the charger goes off
as soon as the battery is fully charged.
Red flashing light ...
... may indicate the following:
No electrical contact between
–
battery and charger – remove and
refit the battery
Malfunction in battery – see also
–
"LEDs on Battery".
Malfunction in charger – have
–
checked by a servicing dealer.
STIHL recommends an authorized
STIHL servicing dealer.
22

Connecting the water supply

Only with wet cuts:
Connect the hose to the water
N
supply network
3
1
2
Push the coupling (1) on to the hose
N
connector (2)
when connected to the water supply
N
network, open the tap
before starting work, open the shut-
N
off valve (3) and allow water to flow
to the abrasive wheel
The water flow rate can be set via the
shut-off valve (3).
After finishing work:
Switch off the machine
N
Close the shut-off valve (3).
N
Disconnect the cut-off machine from
N
the water supply network
Water can also be supplied via the
pressurized water tank (special
accessory).

Switching On

When delivered, the battery is not fully
charged.
It is advisable to charge the battery
completely before using it for the first
time.
Before inserting the battery, remove
N
the battery compartment cover if
there is one; to do this, press both
safety catches at the same time –
cover is unlocked – remove the
cover
Inserting the battery
1
Insert the battery (1) into the battery
N
compartment of the machine –
battery slides into the compartment
– press gently until it clicks into
place – top of battery must be flush
with the top edge of the housing
TSA 230