CHASSIS
Always pay attention to enough pressure in the shock absorber and fork. If
you step with too little pressure (too much negative spring path / sag) in a
slanting position the pedal may hit the ground and you could fall.
MAINTENANCE OF THE DRIVE COMPONENTS
Maintenance work should always only be done by an authorized M1 dealer. If used
carefully and properly the electric drive does not require any maintenance. However,
every 1000 km or at least once a year you should have a safety inspection carried
out by an authorized M1 dealer. He will check the attachments of cables and parts as
well as the electrical system functions and the operational safety of the battery.
WARRANTY / GUARANTEE STATEMENT
M1-SPORTTECHNIK GMBH & CO. KG manufacturer's guarantee
a) 10-year M1-Sporttechnik guarantee for the frame
M1-Sporttechnik guarantees frames labeled with the M1 logo for a total of 10 years
against defects in materials and workmanship.
This guarantee only applies to privately-owned M1 products.
A prerequisite of this guarantee is registration of the product, immediately after
purchase, in the "Service" area of the M1 website www.M1-sporttechnik.de and yearly
service by a specialist dealer which must be recorded in the service log on the back
page of the cycle handbook delivered with the product.
e-bike calssifi cation | safety notices | bike functions | guarantee statement
Please refer to the manufacturer's descriptions
provided with the fork and shock absorber. You
will fi nd the valve for attaching a high pressu-
re shock at the position marked in the photo
(IMPORTANT: Never use a compressor to fi ll
it up). As a rule of thumb for the right pressure
value, set it so that you need about 1 centime-
ter travel for the shock absorber if you sit on the
bike while it is standing still (negative spring
path/ sag). For the fork, you can assume 1.5 to
2 cm travel when sitting on the bike while it is
standing still.
17
Need help?
Do you have a question about the Spitzing Pedelec and is the answer not in the manual?