Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Freescale Semiconductor Manuals
  4. Controller
  5. HVP-KV10Z32
  6. Quick start manual

Freescale Semiconductor HVP-KV10Z32 Quick Start Manual

Controller card high–voltage development platform
Hide thumbs
1
2
3
4
5
6
7
8
9

Advertisement

Quick Links

Download this manual
HVP-KV10Z32
Quick Start Guide
Freescale Controller Card
High–Voltage
Development
Platform

Advertisement

loading
Need help?

Need help?

Do you have a question about the HVP-KV10Z32 and is the answer not in the manual?

Questions and answers

Related Manuals for Freescale Semiconductor HVP-KV10Z32

Summary of Contents for Freescale Semiconductor HVP-KV10Z32

  • Page 1 HVP-KV10Z32 Quick Start Guide Freescale Controller Card High–Voltage Development Platform...
  • Page 2 Quick Start Guide Get to Know the HVP-KV10Z32 USB Mini for Communication, Isolated Power MKV10Z32 Debugging and Power Supply Supply Target Reset/ Bootloader Enable OpenSDA JTAG Open SDA Main Board Interface Primary SWD Isolator Interface Figure 1: HVP-KV10Z32 HVP-KV10Z32 High-Voltage Development Platform...
  • Page 3 Introduction to HVP-KV10Z32 High-Voltage Development Platform The HVP-KV10Z32 controller card is a development board for the Kinetis KV1x family which in combination with one of HVP-MC3PH High-Voltage Development Platform provides ready-made software and hardware development for high-voltage motor control and power conversion applications.
  • Page 4 2) Program a Precompiled Example “LED_demo” for the KV10 Install the Software In the HVP-KV10Z32 drive, copy LED_ and Tools demo.SREC file from the Precompiled Examples folder of the Quick Start • Download and install the IDE toolchain Package.
  • Page 5 MC3PH High-Voltage debug port, mass storage device and Development Platform CDC serial port. 1) Configuring Hardware • Plug the controller card HVP-KV10Z32 into 64-pin PCI connector located at HVP-MC3PH. • Configure jumpers at HVP-MC3PH as is shown in the table below.
  • Page 6 Quick Start Guide Step-by-Step Installation Instructions Loading the PMSM Motor • Connect a line-isolated, current-limited 110 V DC or 90 V AC power supply to Demo Software the power input module with the IEC connector. The power supply current • Launch IAR EWARM v7.20.5 and limit should be set for less than 3 amps.
  • Page 7 Step-by-Step Installation Instructions Monitor the Project • In the Project Options, set the COM port affected as the OpenSDA -CDC with FreeMASTER Serial Port (information available in Device Manager) and set the baud • Launch Freescale FreeMASTER v1.4 or rate/speed to 19200 bps (check the later from the Windows Start menu.

  • Page 8: Get Started

    Freescale, the Freescale logo and Kinetis are trademarks of Freescale Semiconductor, Inc., Reg. U.S. Pat. & Tm. Off. Tower is a trademark of Freescale Semiconductor, Inc. ARM and Cortex are registered trademarks of ARM Limited (or its subsidiaries) in the EU and/or elsewhere. All rights reserved.
  • Page 9 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Freescale Semiconductor HVP-KV10Z32...