Programmable Alarms - AcuRite 01538 Instruction Manual

Programmable Alarms

This display features programmable alarms that sound an alert to notify you when a value (for
outdoor temperature, humidity, wind speed or rainfall) has been reached or exceeded. When
an alarm is triggered, the display emits an audible beep and flashes data in the affected
category (will not interact with Weather Underground
turning ON or OFF the alarms you'd like activated or deactivated, and by inputting your own
values to trigger the alarm.
Setup an Alarm
1. Press and release the "
alarm is shown on the display. "
2. Press and release the "
3. Press and release the "
3. Press and release the "
4. Press and release the "
be shown.
5. Press and release the "
6. Press and release the "
" " button to cycle to the next reading.
Disable an Alarm
1. Press and release the "
alarm is shown on the display. "
2. Press and release the "
3. Press and release the "
4. Repeat steps 1-3, as needed.
NOTE: To disable ALL alarms at once, press and HOLD the "
You will automatically exit alarm SET MODE if no buttons are pressed for 10 seconds.
Enter alarm SET MODE at any time by pressing the "
" button until the reading for which you wish to set an
" will be shown.
" or " " buttons until "
" button. The current HIGH alarm value will be shown.
" or " " buttons to adjust the alarm's HIGH value.
" button. If applicable, the current LOW alarm value will
" or " " buttons to adjust the alarm's LOW value.
" button to end alarm adjustments, OR press and release the
" button until the reading for which you wish to disable an
" will be shown.
" or " " buttons until "
" button to cycle to the next reading.
14
TM ). You can customize the alarms by
" appears.
" appears.
" button for 10 seconds.
" button.