5-In-1 Sensor Installation - AcuRite 01538 Instruction Manual

5-in-1 Sensor Installation Guidelines
INSTALLATION HEIGHT
off the ground, in an open area. Higher is better for wind measurements - The National
Weather Service recommends 33 feet (10 meters) high!
MOUNTING OPTIONS
onto wooden posts or surfaces that are 2x4 (4.5cm x 9.5cm) or larger. The sensor can
also be mounted directly to common 3/4" (20mm) steel pipe (available at hardware
stores and home centers).
LEVEL INSTALLATION
(included on top of sensor) to ensure level
installation for accurate wind
SOLAR CELL INSTALLATION
with the solar cell facing SOUTH. This ensures
the cell receives as much sun as possible and
orients wind direction.

5-in-1 Sensor Installation

1. Fasten mounting base (included) to a post or
pole (not included) using the 4 longer screws
included in the hardware bag.
2. Insert the mounting base into the hole on the
bottom of the sensor.
3. Make sure the arrows on the top of the sensor
are pointed in the proper direction and the
bubble level is centered. The solar cell should
be facing south to properly orient the wind
direction.
4. Fasten the sensor into the mounting base
using the 2 shorter screws included in the hardware bag.
Clear Data Collected During Installation
When installation is complete, press and release the "RESET" button, located on the
back of the display inside the battery compartment, to clear erroneous data from the
display.
Basic Setup is Complete
The 5-in-1 sensor will now synchronize with the display. It may take a few minutes
for synchronization to complete. If both or one of the units appear to be functioning
improperly, please refer to the troubleshooting section.
Mount the sensor at a minimum height of 5 feet (1.5 meters)
The included mounting bracket it designed to screw directly
Use the bubble level
measurement.
Install the sensor
The 5-in-1 sensor is now
ready to use.
NO OBSTRUCTIONS
ABOVE OR AROUND
T H
S O U
12
(1.5 meters)