Interlock Switch Assembly Removal - Maytag RS511 Service Manual

Disassembly Procedures
!
New Door Assembly
(unit with P13278* manufacturing number)
1. Remove plugs from set screws on the door handle.
2. Loosen the set screws on the door handle and remove
door handle.
Tighten side set screw first.
Plastic
plug
Set
screw
Plastic
plug
3. Open door fully.
4. Remove ten Y–drive screws from inner door. (Use
R0193574 driver.)
5. Remove outer door assembly.
NOTE: There are two different outer door styles
(Stainless Steel and Plastic).
Inner door
assembly
Door hinge
Door
ring
weld
Outer door
Stainless Steel Door
22
WARNING
Door
handle
Y-Drive
screw
Rivet
Spring
Latch
16021518 Rev. 0
To avoid risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.
Inner
Door hinge
window
Door
ring
weld
Outer
window
Shadow
box
Outer door
Plastic Door
6. Remove inner door shield.
NOTE: A heat gun may be required to aid in removing
the inner door shield from inner door.
7. Remove screws securing door latch to inner door and
drill rivets to remove door latch.

Interlock Switch Assembly Removal

1. Disconnect power to oven.
2. Remove outer case and open oven door.
3. Remove mounting screws from interlock mounting
bracket and remove wiring from switch assembly.
4. Remove switch assembly.
Secondary
Inner door
Y-Drive
screw
Rivet
Latch
Spring
Monitor
7
8
Primary
2
4
3
5
Insulator
©2002 Maytag Appliances Company