Navman Qube 300 Installation Manual page 10

2 White
3 Yellow
4 Green
5 Light Blue/Black
6 Light Blue
7 Orange
8 Orange/White
10-Way Expansion Connector:
Pin Wire Colour
1 Black
2 Brown
3 Brown/White
4 Black
5 Purple
6 Blue
7 Blue/White
8 Green/White
9 Light Green
10 Grey
Wake from sleep configuration
Wake from sleep can be triggered on MIO-1 Active HIGH ONLY and on DI-1 thru DI-4 in either an Active
HIGH or Active LOW configuration.
When the event is triggered the Qube300 will fully boot up, send any sensor events triggered and after 5
mins return to sleep mode.
Note: If a senor input line is configured for read with ignition on only, Qube300 will boot up but not send
sensor events.
+3.8V DC Reference for Analogue Input
Multi I/O-1 Digital Input OR Digital Output OR Analogue Input 1
(Also Wake from Sleep)
Multi I/O-2 Digital Input OR Digital Output OR Analogue Input 2
RXD-2 RS232 Serial Port 2 Data Input
TXD-2 RS232 Serial Port 2 Data Output
1 W+ Temperature Probe Power Supply
1 WD Temperature Probe Data
Function Description
GND Ground Output
TXD-3 RS232 Serial Port 3 Data Output
RXD-3 RS232 Serial Port 3 Data Input
GND Ground Output
DI-4 Digital Input 4 (Active High/Low) (Wake from Sleep and
RPM Count)
DI-3 Digital Input 3 (Active High/Low) (Wake from Sleep)
DI-2 Digital Input 2 (Active High/Low) (Wake from Sleep)
DI-1 Digital Input 1 (Active High/Low) (Wake from Sleep)
DO-1 Digital Output 1 (Active Low only)
DO-2 Digital Output 2 (Active Low only)
Qube 300 | Installation Manual