Making Fiber Connection - KTI Networks KGS-1260/G Installation Manual

devices. The port performs a negotiation process for the speed and duplex configuration with the connected
device automatically when each time a link is being established. If the connected device is also
auto-negotiation capable, both link partners will come out the best configuration after negotiation process. If
the connected device is incapable in auto-negotiation, the port will sense the speed and use half duplex for the
connection.

3.2 Making Fiber Connection

The SFP slots (FX port) must be installed with an SFP fiber transceiver for making fiber connection. Your
device may come with an SFP transceiver pre-installed when it was shipped.
Installing SFP Fiber Transceiver
To install an SFP fiber transceiver into SFP slot, the steps are:
1. Turn off the power to the device unit.
2. Insert the SFP fiber transceiver into the SFP slot. Normally, a bail is provided for every SFP transceiver.
Hold the bail and make insertion.
3. Until the SFP transceiver is seated securely in the slot, place the bail in lock position.
Dual Speed Support
The SFP slot supports 1000BASE-X based SFP fiber transceivers and 100BASE-FX based SFP fiber
-22-