General information
Opening the plug
connection
Closing the plug
connection
4
2
Commissioning, measuring, calibration
2.1
Opening and closing the IDS plug connection
This section only applies to variants with IDS plug (SenTix
4
3
Guidance
Groove
If necessary, clean the plug connection.
Open the locking device (step 1).
Use your thumb and index finger to press the clips of the connector
together, and pull the connector out of the plug (step 2).
Make sure that the plug connection is completely dry and clean.
Align the guidance of the connector with the groove in the plug and insert
the connector in the unlocked plug until it catches (step 3).
Close the locking device (step 4).
SensoLyt
Plug connection
closed and locked
ba75993d03
®
ORP 900-P
®
... -P).
1
2
06/2017