Main Components; Assembly Components - Stiga SDNSL 108 Hydro Operator's Manual

5. Serial number
6. Article code
7. Weight in kg
8. Type of transmission
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever you
contact an authorized service workshop.
IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.

3.4 MAIN COMPONENTS

The machine is composed of a series
of main components that have the
following functions (fig.1):
A. Cutting-means assembly: this is
the assembly comprising the casing
that houses the rotating cutting
means, and the cutting means.
B. Cutting means: these are what cut the
grass; the fins at the ends help convey the
cut grass towards the discharge chute.
C. Side discharge chute: a safety device
to prevent objects drawn up by the cutting
means from being hurled by the machine.
D. Driving seat: this is where the
machine operator sits. It has a sensor
connected to safety devices for detecting
the presence of the operator.
E. Battery: provides the energy for starting the
engine. Its specifications and regulations
for use are described in a specific manual.
F. Engine: this moves the cutting
means and drives the wheels. Its
specifications and regulations for use
are described in a specific manual.
G. Front bumper: this protects the
front section of the machine.
H. Steering wheel: turns the front wheels.
4. ASSEMBLY
The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or hazards.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling
and its packaging, always making use of
suitable equipment. Do not use the machine
until all the indications provided in the
"ASSEMBLY" section have been carried out.

4.1 ASSEMBLY COMPONENTS

The packaging holds the components needed
for assembly as listed in the table below:
Description
1 Steering wheel
2 Dashboard cover and steering
wheel assembly parts
3 Driving seat
4 Battery
5 Front bumpers
6 Anti-chipping wheels
7 Side discharge chute
8 Cutting-means assembly side
reinforcements (if foreseen).
9 Side guards of the cutting-means
assembly (if foreseen)
10 Envelope containing:
- the instruction manuals and documents
- driving seat assembly screws
- side discharge chute assembly fittings
(for models with side discharge only)
- the connection screws for the battery
cables
- 2 starter keys
- 1 spare 10 A fuse
4.1.1 Unpacking
1. Cautiously open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the packaging
taking the following precautions:
– move the cutting-means assembly
to its maximum height (par. 5.9) to
protect it against damage when the
machine is lifted off the base pallet;
– Lift the machine off the base pallet.
For hydrostatic drive models, move
the rear drive release lever to the
locked position (par.
EN - 6
5.6).