Using The Machine - Stiga SDNSL 108 Hydro Operator's Manual

5.6 HYDROSTATIC TRANSMISSION
DISENGAGEMENT LEVER
This lever has two positions, as
shown on the plate (fig. 12.L):
1. Drive engaged : for all uses,
when moving and during cutting.
2. Drive disengaged : this makes
it much easier to move the
machine by hand, with the
engine turned off.
IMPORTANT To avoid damaging the
transmission unit, this operation must be
carried out only when the engine has stopped
with the pedal (fig. 12.J) at neutral position.
5.7 CUTTING MEANS ENGAGE AND
DISENGAGE FUNCTIONS
The mushroom switch allows you to
engage the cutting means using an
electromagnetic clutch (fig. 12.B):
1. Cutting means engaged.
Mushroom switch pulled
2. Cutting means disengaged.
Mushroom switch engaged.
• On disengaging the cutting
means, a brake is simultaneously
activated which stops their
rotation within a few seconds.
NOTE If you engage the cutting means
without taking the necessary safety
precautions, the engine shuts down and
cannot be restarted (see par. 6.2.2)
5.8 REVERSE GEAR CUTTING
CONSENT BUTTON
By pressing and holding this button (fig.
12.F), it is possible to switch to reverse
gear with the cutting means engaged
without causing the engine to stop.
5.9 CUTTING HEIGHT ADJUSTER LEVER
Use this lever to raise and lower the
cutting-means assembly to one of the 7
different cutting heights (fig. 12.G).
The seven positions for this lever,
shown as «1» to «7» on the label,
correspond to various cutting
heights between 3 and 8 cm.
To go from one position to another,
move the lever sideways and put it
back in one of the stop notches.
5.10 HOUR METER
Hour meter (Fig. 12.H). Indicates the
total number of engine operating hours.

6. USING THE MACHINE

The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or hazards.
6.1 PREPARATION
Before starting to mow, it is necessary to carry
out several checks and operations to ensure you
can work efficiently and in maximum safety.
6.1.1 Filling with oil and fuel
IMPORTANT The machine is
supplied without engine oil or fuel.
Before using the machine check for fuel and
the oil level (par. 7.2, par. 7.3). For refuelling
and oil top-up methods and precautionsent
follow the instructions given in (par. 7.2,
par. 7.3) and in the engine handbook.
6.1.2 Seat adjustment
To change the seat position, loosen the four
fixing bolts (fig. 13.A) and slide it along the
slots. Once you have found the right position,
tighten the four screws (fig. 13.A) thoroughly.
EN - 9