Advertisement
IMPORTANT - Read Before Assembly
Assembly instructions are written for 8 ft. configuration A.
All assembly processes are the same for each configuration
EXCEPT for the order or locations of the assembly process.
Use selected configuration for shelf locations.
Shelf lengths and Garment bars may need to be cut depending upon configuration
desired.
All cut shelf lengths are used in closet configurations supplied. Depending upon
your closet dimensions, some cut lengths may not be usable.
If you choose an 6 ft. closet configuration and the width of your
EXAMPLE:
closet is 6 ft. 4 in., the cut shelf length will be short 4 in. for use. It is recommended
that if your closet is over the selected dimension (6 ft.), then choose a configura-
tion from the next dimension higher (8 ft.).
If you choose an 8 ft. closet configuration and the width of your
EXAMPLE:
closet is 7 ft. 6 in., some shelf lengths may need to be cut 6 in. shorter in length
to fit closet dimensions.
VERIFY SHELF MEASUREMENTS
MEASURE - MARK - MEASURE AGAIN
Chosen configuration may not require use of all hardware or components sup-
plied.
It is recommended to secure hardware into wall studs for overall strength and
stability of closet system.
If choosing a custom designed configuration, modifications to the instructions pro-
vided will be necessary.
All configurations provided may be reversed.
STEP 1 - Determining Your Dimensions
1.
Locate your desired configuration (Instructions are written for 8 ft.
configuration A).
2.
Double hang shelf is created with 2 - 4 ft. shelf lengths.
3.
Long hang is created by cutting a 2 ft. shelf to 21 3/4 in. wide. (Cut may be
adjusted for any width under 2 ft.)
2
3
3
STEP 2 - Attaching Garment Bars
1.
4ft. garment bars are used for double hang.
2.
On the pilot hole side of the bar, measure in 4 in. from the end.
3.
Mark location & repeat for other end.
4.
Align side of bar spacer with the mark.
5.
Secure with #8 1in. screw.
6.
Repeat at each marked location.
1
4
7.
Find bar center & mark location.
8.
Align center of bar spacer at marked location.
9.
Secure with #8 1in.screw.
10. Repeat for 2nd 4ft. bar.
7
8
11. Place notched bar spacer / bar tight on inside rail of shelf.
12. Flush bar & shelf.
13. Secure bar spacer to shelf rail with #8 1 in. screw.
14. Repeat at each bar spacer location.
15. Repeat for each bar & shelf.
11
12
2
3
5
9
13
Advertisement
