Table of Contents
Advertisement
Quick Links
1.
Unpack the box. Without tearing the plastic over the UT, lift it out of the
box, unfold the flaps, and slide it out.
2.
Insert the SIM card supplied by your service provider.
3.
Install the battery and completely charge it before using the terminal.
Hughes 9211 Quick Start Guide
4.
Power on the UT by long pressing the Power button (>2 seconds).
Button function, long press (>2 sec)
Button function, short press (<2 sec)
5.
Set up the UT in an open area and allow it to acquire a GPS fix. The GPS
satellite icons on the display will indicate when the UT can see the GPS
satellites. The GPS icon will go solid, and the satellite icons will disappear
when the UT has a fix.
6.
Point the UT at the satellite using the pointing information on the LCD.
To satellite
7.
Maximize the signal shown on the LCD by adjusting the direction and
elevation angle of the unit. You can also press the audio button to get an
audible indication of the signal. Signal strength should be 52 to 55.
8.
Connect an Ethernet cable from your computer to the UT.
Open Internet Explorer or Firefox and browse to 192.168.128.100 to access
the home page of the UT Web User Interface.
3501075-0001_a
Advertisement
Table of Contents
Related Manuals for Hughes 9211
Summary of Contents for Hughes 9211
- Page 1 Hughes 9211 Quick Start Guide Unpack the box. Without tearing the plastic over the UT, lift it out of the Power on the UT by long pressing the Power button (>2 seconds). box, unfold the flaps, and slide it out.
- Page 2 LCD, you can connect to the UT. Default SSID is Streaming section. “Hughes 9211.” The home page address is 192.168.128.100. Press the “Register with network” button. The support page shows useful information about the terminal and can The UT will register and attach to the Inmarsat network.
Need help?
Do you have a question about the 9211 and is the answer not in the manual?
Questions and answers