Related Manuals for GalileoSky v 7.0
Summary of Contents for GalileoSky v 7.0
- Page 1 Installation and Connection of Galileosky Tracking Device User Manual www.galileosky.com...
-
Page 2: Table Of Contents
Preparation of the connector a tracking device ........4 SIM-cards inserting ................5 Preparation of antennas ................. 7 Installation of Galileosky components in a vehicle ........9 Connection schemes ................9 Galileosky tracking device placement in the driver’s cabin ....11 GSM-antenna and GLONASS/GPS-antenna placement ....12... -
Page 3: Necessary Tools, Devices, Materials
Installation and Connection of Galileosky Tracking Device version 7 dated from 19.06.2018 Necessary Tools, Devices, Materials To connect Galileosky tracking devices (hereinafter – tracking device, GPS tracker) you should have: Electrical tools. Multimeter. Set of connecting wires with fuses. -
Page 4: Setting Of Galileosky Device To Switch-On
Installation and Connection of Galileosky Tracking Device version 7 dated from 19.06.2018 Setting of Galileosky Device to Switch-on Preparation of the connector a tracking device Together with a device, you get a counterpart of socket and several crimped conductors. On the back of the body, there is a schematic representation of the contacts to be connected and location of main service openings (Picture 1). -
Page 5: Sim-Cards Inserting
Installation and Connection of Galileosky Tracking Device version 7 dated from 19.06.2018 turn the contacts the locking mechanisms up and along the sides and insert them into the socket until clicking position (Picture 3). Pic. 3 Crimped terminal conductor ATTENTION! When you install the conductors observe the polarity –... - Page 6 Installation and Connection of Galileosky Tracking Device version 7 dated from 19.06.2018 Pic. 5 Inserting the SIM- cards insert the SIM-holder with the card into the tracking device carefully without applying excessive force until locking focusing on the key drawn on the tracking device body (Pic.
-
Page 7: Preparation Of Antennas
Preparation of antennas Together with the Tracking device, you get a GSM-antenna and a GLONASS/GPS-antenna. The antennas differ in appearance and functionality. There are 2 types of antennas connectors in Galileosky tracking devices: F-type connector Fakra connector The GSM-antenna (Picture 7) is a passive one and is connected to the GSM-antenna plug. - Page 8 Installation and Connection of Galileosky Tracking Device version 7 dated from 19.06.2018 Pic. 9 Connecting GLONASS/GPS- antennas with F type connector Connection of GSM-antennas and GLONASS/GPS antennas with Fakra connector (picture 10) is carried out up to clicking position to the correspondent connectors as shown in Picture 11.
-
Page 9: Installation Of Galileosky Components In A Vehicle
Installation of Galileosky components in a vehicle Connection schemes Galileosky tracking devices can be connected to on-board power system by three different schemes. Riser diagrams and description of operation of these diagrams are shown in Appendix №1 to this document. - Page 10 Installation and Connection of Galileosky Tracking Device version 7 dated from 19.06.2018 connect the black wire to the negative plug of the battery via 1А fuse; connect the red wire to the positive plug of the battery via 1А fuse.
-
Page 11: Galileosky Tracking Device Placement In The Driver's Cabin
Galileosky tracking device placement in the driver’s cabin Galileosky tracking device is installed in the cabin under the shell of the control panel or fore- body. Possible ways of tracking device placement are shown in Picture 15 of this manual. -
Page 12: Gsm-Antenna And Glonass/Gps-Antenna Placement
Installation and Connection of Galileosky Tracking Device version 7 dated from 19.06.2018 GSM-antenna and GLONASS/GPS-antenna placement The order of connection and placement of GSM-antenna and GLONASS/GPS-antenna is the following: place the GSM-antenna in the cabin as close to the windscreen as possible (Pic. 15) or ...