Miele EVS 6214 Operating And Installation Instructions page 34

Problem
The edge of the bag is
not completely sealed.
The seal was not strong
enough and has
opened.
The bag is not maintain-
ing the vacuum al-
though the weld seam
is intact.
Cause and remedy
The edge of the bag was not positioned centrally
along the sealing bar or has slipped.
 Place the edge of the bag centrally along the seal-
ing bar. Make sure that the edge of the bag is par-
allel to the sealing bar and protrudes over it by ap-
prox. 2 cm.
The bag is wider than 25 cm.
 Use vacuum sealing bags with a maximum width
of 25 cm.
The edge of the bag is dirty (inside and out). For a
perfect weld seam the edge of the bag must be dry
and grease-free in the area of the seam.
 Fold the edges of the vacuum sealing bag out-
wards for filling. This will give you a clean, perfect
weld seam.
The edge of the bag was not positioned smoothly and
without creases on the sealing bar.
 Position the bag smoothly and without creases
along the sealing bar.
The sealing level was too low.
 Start the vacuuming process again with a new va-
cuum sealing bag and select a higher sealing level.
The rubber on the counterpressure bar is not evenly
fitted.
 Flatten the rubber.
The sealing bar and/or the counterpressure bar is
damaged.
 Call Miele to have it replaced.
The vacuum sealing bag has been damaged by sharp
pointed objects, e.g. pointed pasta shapes or a bone.
 Start the vacuuming process again with a new va-
cuum sealing bag, on a lower vacuum level if ne-
cessary.
 Use an external container if possible.
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
Problem solving guide
33