Identification Of Symbols - Craftsman 358.740160 Operator's Manual

IDENTIFICATION OF SYMBOLS

WARNING:
Chainsaws can be
dangerous! Careless or
improper use can result
in serious or fatal injury
to the operator or
others.
Please read the operator's
manual carefully and make
sure you understand the
instructions before using the
machine.
Always wear:
Approved protective helmet

Approved hearing

protection
Protective goggles or a

visor
Both of the operator's hands
must be used to operate the
chainsaw.
Never operate a chainsaw
holding it with one hand only.
Contact of the guide bar tip
with any object must be
avoided.
WARNING: Tip
contact may cause the
XX
guide bar to move
suddenly upward and
backward (so-called
kickback), which may
cause serious injury.
Primer (air purge) bulb.
The engine is stopped by
switching the ignition off using
the stop switch.
Fuel fill.
Other symbols/decals on the machine refer to
special certification requirements for certain
markets.
The Emissions Compliance Period referred to
on the Emission Compliance label indicates the
number of operating hours for which the engine
has been shown to meet Federal emissions
requirements.
Maintenance, replacement, or repair of the
emission control devices and system may be
performed by any nonroad engine repair
establishment or individual.
3
50:1 gasoline to oil ratio.
Do not use E15 or E85
blended fuels.
Bar and chain oil fill.
Lock chain brake.
Unlock chain brake.
Chain brake unlocked/locked.