SATO MB400 User Manual page 23

Core-less rolls
After removing both of the label guide bosses
on the sides with the driver (attached
accessory), set the roll by following the
directions 4, 5 and 6 on page 21 to 22.
Setting the Label Guide Boss
If the width of the label is fixed, the boss can be fixed.
• After setting the roll on the label guide,
fix it in place by sliding the "O-ring" on
the bottom left to the edge of the label
guide.
* Setting labels will be easier when the
label guide is fixed.
* When using core-less paper, the label
guide must be always fixed.
Above are the steps for setting the papers during the Continuous mode.
PN9001114
4 5
Label guide boss
The "O-ring"
Page 23