Automatic Washing/Drying; When The Programme Is Finished - Whirlpool AWF96140 Instructions For Use Manual

Warning: only a maximum 6 kg of dry laundry can be loaded
otherwise the dried laundry will be not satisfactory.
WASHING:
Open the drawer, choose the detergent and put in the correct amount.
Refer to the list of washing programmes according to fabrics to be washed (e.g. very dirty
cotton) and without pressing Start button, prepare wash as described:
Turning the selector knob, the required programme is activated.
The display will show the settings for the programme selected.
Adjust the wash temperature if necessary.
Press the option buttons (if required)
Check that the tap is turned on and that the discharge hose is positioned correctly.
DRYING:
Select the degree of dryness that you require.
This ranges from Extra Dry (
( ) for items that will be put away without ironing, to iron dry (
suitable for ironing.
If you wish to select a timed drying cycle, press the "drying selection" button until
the required time indicator lights up.
Press the "Start/Pause" button.
When the "Start/Pause" button is pressed the machine sets the working sequence in motion.
The programme carries out with the programme selector stationary on the selected
programme till cycle ends.
At the end of the wash phase the display will shown the drying time remaining.
The washer-dryer will then complete the entire drying programme.
The drying programme indicator will be on until the cool down phase will begin and the
indicator " " will go on.

When the programme is finished

The word "End" will appear on the display.
Wait for the door lock to be released (about 2 minutes after the programme has finished).
The "Door Security" indicator light will go out.
Switch off the machine by turning the programme selector on the "OFF" position. Open the
door and remove the laundry. Turn off the tap.

Automatic washing/drying

) for bath towels and bathrobes, through Cupboard Dry
60
) that leaves the laundry