You should wipe out the dryer drum with a damp cloth before using to re- move dust from storing or shipping. Thank you for buying a Whirlpool ap- pliance. Please complete and mail the Owner Registration Card provided with this product. Then complete the form below.
Important Safety Instructions To reduce the risk of fire, electric shock, or in- jury to persons when using your Thin Twin, fol- low basic precautions, including the following: b Read all instructions before using the Thin Twin. NEVER wash or dry items cleaned, washed, soaked in or spotted with wax, paint, gasoline or flammable fluids in the Thin Twin.
Important Safety Instructions Continued Additional safety instructions and your responsibilities ALWAYS shut off the gas valve before leaving on vacation. ALWAYS unplug the power supply cord before attempting to service the off GAS VALVE Thin Twin. Shut yours is a gas dryer. DO NOT machine wash or dry glass fiber materials.
Washer Operating Instructions The drawings in this book may vary slightly from your Thin Twin model. They are designed to show the different features of all the models covered by this book. NOTE: Your model may not include all the features shown. Starting your washer Be sure to measure and add detergent, then place a sorted load in the washer before starting it.
3. Select cycle and wash time Start the washer Push in the Cycle Control Knob and turn it clockwise. Stop when the indicator on the knob’s outer ring points to the number in the wash cycle you want. The numbers are minutes of wash time.
Page 8
Washer Operating Instructions Continued Regular Cycle A cycle for sturdily constructed fabrics that are moderately to heavily soiled. to Selected Level High Speed, Spray Rinses Permanent Press Cycle A cycle designed for lightly to moder- ately soiled permanent press and some synthetic fabrics.
Page 9
Knits Gentle Cycle A cycle that gently washes and spins moderately to lightly soiled delicate items and washable knits. to Selected Level Low Speed, Spray Rinses Alndicates that machine is pausing for a brief soak period. Soak and Pre-Wash Cycles Brief periods of agitation and soak time help remove heavy soils and certain stains that need extra pretreatment.
Page 10
Washer Operating Instructions Continued Super Wash Cycle Use for washing heavrly soiled loads that require maximum soil removal. Double the amount of detergent recom- mended when using the SUPER WASH Cycle. to Selected Level Agitation PARTIAL DRAIN No lo Selected Level After the partial drain, the washer automatically refills and goes into the...
Other Operating Instructions Rinse and spin When using extra detergent for heavily soiled clothes, or washing special-care items, you may want an extra rinse and spin. 1. Push Cycle Control Knob in. 2. Turn clockwise to one of the dots on the dial, as illustrated.
Liquid fabric softener dispenser A liquid fabric softener dispenser is available for the washer. Write to: Whirlpool Corporation Attention: Customer Service Dept. 1900 Whirlpool Drive LaPorte, IN 46305 and order the LT7000XT fabric softener dispenser, Part No. 3350634.
MAGIC CLEAN@ lint filter The lint filter at the bottom of the washer basket cleans itself. During agi- tation, wash and rinse water pass over the filter, separating lint from water. The collected particles of lint are then continuously spun away from the filter and washed out of the system at the end of the wash cycle.
Dryer Operating Instructions Starting your dryer Before starting your dryer, be sure laundry IS sorted and loaded properly. Make sure the door is tightly closed. 1. Select a cycle and time by turning the Cycle Control Knob either way to point to the cycle and time setting you want.
The automatic cycles The automatic cycles allow you to select the degree of dryness you prefer for the clothes being dried. The electronic DRY-MISER@ control is an electronic sensor that determines the amount of moisture in the clothes. The dryer automatically shuts off when the proper dryness is reached.
Dryer Operating Instructions Continued TIMED DRYING cycle Use the TIMED DRYING Cycle for any load you want to dry by time. Turn the Cycle Control Knob to the number of minutes you want. The last 8 minutes of this cycle are without heat.
Dryer Operating Instructions Continued Changing the dryer light Electrical Shock Hazard Unplug the power supply cord or turn off the electrical power before changing the light bulb. Failure to do so may result in electrical shock. The dryer light is located inside the dryer drum on the front wall.
Lint Removal And Cleaning Clean the lint screen before each load. The lint screen is located at the front of the dryer door opening. To clean: 1. Lift screen straight up. 2. ROLL lint off the screen with your DO NOT rinse or wash fingers.
Lint Removal and Cleaning Continued Thern!ostat Heat Inlet duct Motor ElectrIcal SUPPlY Clean lint gathered inside the dryer. Lint can gather inside the dryer and FIRE HAZARD. This lint create a should be removed at least every to 3 years, or more often, depending on dryer usage.
Is the lint screen clean? See page 19 of this book for cleaning instructions. Is exhaust system clean? Cleaning should be done by a qualified person. 2. If you need assistance’.. Call Whirlpool COOL-LINE@ service assistance telephone number. Dial free from anywhere in the U.S.:...
Page 22
United States. To locate the authorized Whirlpool service company in your area, call our COOL-LINE@ service assistance telephone number (see Step 2) or look in your telephone directory Yellow Pages under: SERVICE COMP.~N,ES...
C. Pick up and delivery. This product is designed to be repaired in the home. Damage to washer/dryer caused by accident, misuse, fire, flood, acts of God or use of products not approved by Whirlpool. Any labor costs during the limited warranties. WHIRLPOOL CORPORATION...