Door Handle; “Door Security” Indicator Light; “Start/Pause” Button; Cancelling The Programme - Whirlpool AWF96140 Instructions For Use Manual

Door handle

Press the finger-bar inside the door handle to open the door.
"DOOR SECURITY" indicator light
The " Door Security " indicator light is illuminated when the door is fully closed and the machine is ON.
When " Start/Pause" is pressed on the machine with the door closed the indicator will flash
momentarily and then illuminate.
If the door is not closed the indicator will continue to flash.
A special safety device prevents the door from being opened immediately after the end of the cycle.
Wait for 2 minutes after the wash cycle has finished and the " Door Security " light has gone out
before opening the door. At the end of the cycle turn the programme selector to "OFF " .
"START/PAUSE" button
Press to start the selected cycle .
NOTE: When the "START/PAUSE" button has been pressed,
the appliance can take few seconds before it starts
working.
Changing the settings after the programmes has started (PAUSE)
Press and hold the "START/PAUSE" button for about 2 seconds, the flashing lights on the
options buttons and time remaining indicator will show that the machine has been paused,
adjust as required and press the "START/PAUSE" button again to cancel the flashing lights.
If you wish to add or remove items during washing, wait 2 minutes until the safety device
unlocks the door.
When you have carried out the manoeuvre, close the door, press "START/PAUSE" button and
the appliance will continue working where it left off.

CANCELLING THE PROGRAMME

To cancel the programme, set the selector to the "OFF" position.
Select a different programme.
Re-set the programme selector to the "OFF" position.
42
A
B
C