Use and Care guide
Automatic Washing/Drying Cycle
You cannot exceed the maximum dryable
load of laundry indicated in the programme
table, otherwise the laundry will not be
dried satisfactory.
- Washing
• Open the drawer and put in the correct amount
of detergent.
• Refer to the list of washing programmes for
the fabrics to be washed (e.g. very dirty cotton)
and turn the selector knob to the required
programme.
• Adjust the wash temperature if necessary.
• Press the option buttons (if required).
• Check that the tap is turned on and that the
discharge hose is positioned correctly.
- Drying
• Select the degree of dryness that you require:
EXTRA DRY
(suitable for towels, bathrobes and bulky
loads).
IRON DRY
(that leaves the laundry ready for ironing).
CUPBOARD DRY
(for items that will be put away without
ironing).
• Press the START/PAUSE button.
• At the end of the wash phase the display will
show the drying time remaining.
22
• When the programme is finished the word "End"
will appear on the display. After 5 minutes the
appliance will go into standby mode (on certain
models, the display will show two lines).
• Sw i tch o f f t he ma c hi n e by t ur n i ng the
programme selector to the OFF position.
• Open the door and remove the laundry.
• Turn off the tap.
CANCELLING THE DRYING PROGRAMME
• To cancel the drying programme, press and
hold the DRYING SELECTION button for about
3 seconds.
WARNING:
After cancelling the drying programme,
the cool down phase will begin and you
must wait for about 10/20 minutes before
opening the door.
In order to ensure the correct operation of the
appliance, it is advisable not to interrupt the
drying phase unless it is absolutely necessary.