SATO D508 Operator's Manual page 9

1.1 GENERAL SPECIFICATIONS (CONT'D)
CONTROLS AND SIGNALS
On-Line LED
Power LED
Error LED
LED Display Panel
On/Off-Line Button
Label Feed Button
Power On/Off Button
Self Diagnostics
POTENTIOMETER ADJUSTMENTS
Adjustment Potentiometers
DIP switches
INTERFACE CONNECTIONS
Parallel (Option)
Serial (Option)
USB (Option)
LAN (Option)
RFID (Option)
Wireless LAN (Option)
*All specifications subject to change without notice.
SATO D508/D512 Operator Manual
Attributes
7-Segment Single Character
VR1: Offset level (DIPSW6 = OFF)
VR1: Print darkness (DIPSW6 = ON)
VR2: Eye Mark
VR3: Gap sensor (to adjust the threshold)
VR4: Label pitch offset
DIP-SW -1,2,3 : Operation mode(Print mode/Download mode)
DIP-SW -4 : Reserved (constantly OFF)
DIP-SW -5 : Head check (ON-Enabled / OFF-Disabled)
DIP-SW -6 : VR1 function switch
(ON-Print darkness level / OFF-Offset)
DIP-SW -7 : DATA dump (ON-HEX dump print / OFF-Normal print)
DIP-SW -8 : Reserved (constantly OFF)
RS232C (up to 57.6K bps) Hardware Flow Control (Ready/Busy) Soft-
ware Flow Control (X-On/X-Off)
Bi-directional Status
USB Specification Version 1.1
10/100 Base-T
802.11 b/g (internal)
Green
Green
Red
Front Panel
Front Panel
Front Panel
Head check
Paper end
Cover open
Test print
IEEE1284
TBA
Section 1: Introduction
Page 1-5