SATO D508 Operator's Manual page 54

SECTION 6: TROUBLESHOOTING
6.2 USING THE IEEE1284 (PARALLEL) INTERFACE (CONT'D)
This may mean that the computer doesn't know the
printer is there. Verify that:
a. Both ends of the cable are securely inserted
b
c. The cable is not defective. There are other
6. When you send the print job to the printer and it
does not respond, and there is no error mes-
sage on the PC:
A. Check your data stream to make sure it com-
plies with standard SATO commands.
B. Verify that you've included all required parame-
ters in the data stream.
C. Verify the following:
• You have not typed a "0" (zero) for an "O"
(letter) or vice-versa.
• You have not missed any SPBL commands/
headers where they're needed.
• Make sure all printer command codes are
capital letters.
7. If you've checked all of the above and the printer still isn't
printing, you may want to try a Receive Buffer DATA Dump to
determine what (if anything) the printer is receiving from your
computer. To print DATA Dumps see page 3-11, Configura-
tion and Operation.
The parallel port is now listening for incoming data. Send
your print job. The printer will now print (only once) a DATA
Dump of everything it received from the host computer. Each
2-digit hexadecimal character represents a character the
printer received. It may be tedious, but now you can analyze
and troubleshoot the data stream.
8. While checking the DATA Dump printout, look out for the
sequence 0D 0A, which is a combination of Carriage Return
and Line Feed characters. The command string should be
continuous, and you should not see CR or LF characters
between the SBPL commands.
Page 6-2
into their respective connectors
The printer is ON LINE
things that can cause this error message on
your computer, but at this stage, a defective
cable may be one of the reasons
Observations
SATO D508/D512 Operator Manual