Command Structure
Command Function
Input to Printer
Printer Output
Special Notes
Page 98
Set Sensor Type
<ESC>CIa
a
=
0
Disable Sensor
1
Reflective (Eye-Mark ) Sensing
2
Transmissive (Label Gap or Notch) Sensing
Example:
<ESC>CI1
Placement:
This command should be sendt in a separate data
stream.
Default:
<ESC>CI2 (Transmissive Sensing)
To select the top-of-label sensing method.
Theres is no printer output as a result of this command.
1. The reflective Eye-Mark must be a minimum of .125" wide and at
least 1.0" long. It should be parallel to the platen and centered on
the underneath side of the label
2. The transmissive gap must be a minimum of 0.125" wide.
3. See "Sensing" on page 8 for more information on label indexing.
PN 9001092 Rev. A
CX208/212 Programming Guide
SATO CX208/212 Printers