Table of Contents
Advertisement
CX208/212 Programming Guide
command stream will calibrate the printer in the thermal transfer mode for gap
sensing:
<ESC>A<ESC>CP1<ESC>CI2<ESC>CA<ESC>Z
When Auto-Calibrate is enabled, the printer will automatically attempt to calibrate
when it detects an out-of-paper condition (10" of platen feed after a label is printed
without detecting a label edge or sense mark). If the calibration is successful, the
printer shall move paper to the next index mark and resume normal operations. If the
calibration is not successful, the printer shall indicate an out-of-paper condition by a
red READY LED and the printer shall restore the original index circuit settings.
SATO CX208/212 Printers
PN 9001092 Rev. A
Page 9
Advertisement
Table of Contents
