Changing The Battery; Side Extract Battery; Transporting The Battery - Taylor-Dunn Huskey C-426 Operator's Manual

CHANGING THE BATTERY

Side Extract Battery

Remove
WARNING
Before removing the battery:
1) Park the vehicle on a level surface.
2) Position the vehicle as close as possible to the platform where the battery will
be stored.
3) Place the Directional Control switch in the center OFF position.
4) Make sure the Start switch is in the OFF position.
5. Open the upper battery door.
6. Disconnect the battery cable.
7. Remove the lower battery door.
8. Using a winch or other powered device, pull the battery out of the vehicle and onto the
battery storage platform.
Install
1. Confirm the start switch is OFF.
2. Ensure the vehicle is as close as possible to the battery storage platform.
3. Place battery next to vehicle on the platform.
4. Push the battery all the way into the compartment.
5. Install the lower battery door.
6. Connect the battery cable.
7. Close and latch the upper battery door.

Transporting the Battery

WARNING
• Use the proper equipment when handling and transporting batteries. Equipment
that is used to lift and support batteries should be rated at a minimum of 1.5
times the total battery weight.
• Keep all body parts out from underneath any battery that is not installed and
latched in the vehicle.
Failure to follow these rules may result in severe bodily injury and/or property
damage.
Page 44 C0-426-48AC Operator's Manual
MC-425-14