Bauer 1852C-B Owner's Manual & Safety Instructions page 9

troubleshooting
problem
Tool will not start. 1. Battery Pack not properly
2. Dust Cup not locked to Motor
3. Switch not fully in ON position.
4. Battery Pack not properly
5. Battery Pack burnt-out.
6. Internal damage or wear. (Motor
Tool operates slowly. 1. Forcing tool to work too fast.
2. Low charge on Battery Pack.
3. Dirty Filter.
Performance Motor worn or damaged.
decreases over time.
Excessive noise Internal damage or wear. (Motor
or rattling. or bearings, for example.)
Low suction. 1. Dirty Filter.
2. Low charge on Battery Pack.
Turns itself off. 1. Dirty Filter.
2. Damaged Battery Pack.
3. Blocked Motor Housing vents.
4. Damaged Motor.
Overheating. 1. Forcing tool to work too fast.
2. Blocked Motor Housing vents.
3. Clogged Filter.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect Battery pack before service.
Item 64148
possible causes
connected.
Housing.
charged.
or Switch, for example.)
For technical questions, please call 1-888-866-5797.
Likely Solutions
1. Remove Battery Pack to make sure there are
no obstructions and the battery contacts are
clean. Reinsert the Battery Pack according to
its shape (it should only fit one way) and press
firmly until the Battery Pack locks in place.
2. Press Release Button. Pull Dust Cup and
Motor Housing apart slightly then press them
back together until you hear the Release Button
engage (click) locking the two pieces together.
3. Push the On/Off switch fully to the On position.
4. Make sure the Charger is connected and
operating properly. Give enough time for
Battery Pack to recharge properly.
5. Dispose of old Battery Pack
properly or recycle. Replace Battery Pack.
6. Have technician service tool.
1. Allow tool to work at its own rate.
2. Recharge Battery Pack.
3. Clean Filter and Dust Cup.
Have qualified technician replace motor.
Have technician service tool.
1. Clean Filter and Dust Cup.
2. Recharge Battery Pack.
1. Clean Filter and Dust Cup.
2. Dispose of old Battery Pack
properly or recycle. Replace Battery Pack.
3. Using a dry clean cloth, wipe
Motor Housing vents clean.
4. Have technician service tool.
1. Allow tool to work at its own rate.
2. Using a dry clean cloth, wipe
Motor Housing vents clean.
3. Clean Filter and Dust Cup.
Page 9