Advertisement
Grommet Stop Screw & Kep Nut
Grommet Stop, Screw, and Standoff
8) Install electrical body of new clutch on feed shaft. It may be necessary to turn clutch upon installa-
tion on the small end of the Feed Shaft to get their corresponding flats to align. There is a certain
amount of 'feel' involved with installing the electrical portion of the clutch on the feed shaft end. Do
not attempt to force the clutch onto the Feed Shaft. When the flats of the (2) components are aligned,
the clutch will slip easily on the shaft. During this installation, orient the clutch so that its anti-rotation
lugs align with the top cover grommet screw installed in step #7 above and push clutch onto shaft as
far as it will go.
Clutch Anti-Rotation Lugs Aligned
Installing Electric Clutch
with Top Cover Grommet Screw
on Feed Shaft
9) Install new clutch gear assembly on clutch making sure that the clutch friction disk is in assembly
(held to clutch gear assembly via permanent magnet). Mesh the outer part of the gear with the exist-
ing folder gear & push on as far as it will go.
Make Sure that Friction Disk is at-
Clutch Gear Installed on
tached (magnetically) to Clutch Gear
Magnetic Clutch
with Smooth Side Towards Gear
10) Install .75" OD Fender Washer received with Retro-Kit on end of feed shaft. Then install small E-
Ring to retain clutch in position.
(4)
Advertisement
