Advertisement
New Chip Installed in Socket---
Confirm That All Chip Pins are
Straight and Installed in Socket
When Installing New Chip in Board, Carefully Align Pins on Both Sides
of Chip with Socket and Seat Chip Firmly. Do Not Force Chip and
Bend the Pins. Bent Pins May Be Straightened, but Will Require Even
More Care in Installation to Assure that They Do Not Bend Again
14) Re-install circuit board cover, folder side cover, and power cord. Re-energize power source if
locked out.
15) Turn on folder and confirm that the unit powers up. Default setting on chip included with retro-kit
is Disk-Type clutch with 'Test' button on operator panel. If unit is older & has an operator panel with
'bypass' on it and a bypass slot in the top cover, the board setting must be changed to 'bypass'. Con-
tact M-Y tech support at 800-225-5644 for instructions on how to change 1812 board settings.
16) Reset the paper retarder which is also called a sheet separator. It is directly below the feed
wheel. Push the feed tray down and lock in the paper loading position & lift the top cover.
Make Sure To Install Chip with
the Cutout and Dot (Indicating
Pin #1) Towards the Rectangular
Capacitor. If the Chip Is Installed
Backwards, the Board Will Not
(6)
Function
Advertisement
