Panasonic K-NL404K/G User Manual page 53

Speed is to control PTZ movement speed. The value ranges from 1 to 8.The speed 8 is faster than speed
1. You can use the remote control to click the small keyboard to set.
You can click and
The PTZ rotation supports 8 directions. If you are using direction buttons on the front panel, there are only
four directions: up/down/left/right.
In the middle of the eight direction arrows, there is a 3D intelligent positioning key. See Figure 4-40.
Please make sure your protocol supports this function and you need to use mouse to control.
Click this key, system goes back to the single screen mode. Drag the mouse in the screen to adjust
section size. The dragged zone supports 4X to 16X speeds. It can realize PTZ automatically. The smaller
zone you dragged, the higher the speed.
Name Function
key
Zoom
Focus
Iris
In Figure 4-39, click
4-41.
Please refer to the following sheet for detailed information.
Please note the above interface may vary due to different protocols. The button is gray and cannot be
selected once the current function is null.
of the zoom, focus and iris to zoom in/out, definition and brightness.
Figure 4-39
Figure 4-40
function Shortcut
key
Near
Near
│
close

to open the menu, you can set preset, tour, pattern, scan and etc. See Figure
Figure 4-41
Function
key

47
function Shortcut
key
Far

Far ►
│
Open
