Panasonic K-NL404K/G User Manual page 238

Questions
I can not connect to the
IPC
After I set the
resolution as 1080P, my
monitor can not display.
After I login the Web , I
can not find the remote
interface to add the IPC.
There is IP and gateway, I
can access the internet
via the router. But I can
not access the internet
after I reboot the NVR.
I use the VGA montior.I
want to know if I use the
multple-window mode, I
see the video from the
main stream or the sub
stream?
Daily Maintenance
Please use the brush to clean the board, socket connector and the chassis regularly.

The device shall be soundly earthed in case there is audio/video disturbance. Keep the device away

from the static voltage or induced voltage.
Please unplug the power cable before you remove the audio/video signal cable, RS232 or RS485

cable.
Always shut down the device properly. Please use the shutdown function in the menu, or you can

press the power button in the rear pane for at least three seconds to shut down the device.
Otherwise it may result in HDD malfunction.
Please make sure the device is away from the direct sunlight or other heating sources. Please keep

the sound ventilation.
Please check and maintain the device regularly.

Please make sure the IPC has booted up.

IPC network connection is right and it is online

IPC IP is in the blacklist.

The device has connected to the too many IPC. It cannot transmit

the video.
Check the IPC port value and the time zone is the same as the

NVR.
Make sure current network environment is stable.

NVR
Shut down the device and then reboot. When you reboot, please press
the Fn button at the same time and then release after 5 seconds. You
can restore NVR resolution to the default setup.
Please clear the Web controls and load again.
Please use command PING to check you can connect to the gateway
or not. Use telnet to access and then use command "ifconfig –a" to
check device IP address. If you see the subnet mask and the gateway
has changed after the reboot. Please upgrade the applications and set
again.
For 32-channel series product, the 9/16-window is using the sub

stream.
For 4/8/16 series product, system is using the main stream no

matter you are in what display mode.
Solutions
232