Panasonic K-NL404K/G User Manual page 236

Questions
NVR cannot control PTZ.
I cannot log in client-end
or web.
There is only mosaic no
video when preview or
playback video file
remotely.
Network connection
not stable.
Burn error /USB back
error.
Keyboard cannot control
NVR.
Front panel PTZ error

PTZ decoder setup, connection or installation is not correct.

Cable connection is not correct.

PTZ setup is not correct.

PTZ decoder and NVR protocol is not compatible.

PTZ decoder and NVR address is not compatible.

When there are several decoders, please add 120 Ohm between

the PTZ decoder A/B cables furthest end to delete the
reverberation or impedance matching. Otherwise the PTZ control
is not stable.
The distance is too far.

For Windows 98 or Windows ME user, please update your system

to Windows 2000 sp4. Or you can install client-end software of
lower version. Please note right now, our NVR is not compatible
with Windows VISTA control.
ActiveX control has been disabled.

No dx8.1 or higher. Please upgrade display card driver.

Network connection error.

Network setup error.

Password or user name is invalid.

Client-end is not compatible with NVR program.

Network fluency is not good.

Client-end resources are limit.

Current user has no right to monitor.

Network is not stable.

is
IP address conflict.

MAC address conflict.

PC or device network card is not good.

Burner and NVR are in the same data cable.

System uses too much CPU resources. Please stop record first

and then begin backup.
Data amount exceeds backup device capacity. It may result in

burner error.
Backup device is not compatible.

Backup device is damaged.

NVR serial port setup is not correct

Address is not correct

When there are several switchers, power supply is not enough.

Transmission distance is too far.

230
Solutions