Panasonic K-NL404K/G User Manual page 223

Before setup, please check the following connections are right:
PTZ and decoder connection is right. Decoder address setup is right.

Decoder A (B) line connects with NVR A (B) line.

Click Save button after you complete setup, you can go back to the monitor interface to control speed
dome.
Please refer to the following sheet for detailed information.
Parameter Function
Channel
PTZ Type
Protocol
Address
Baud Rate
Data Bit
Figure 5-85
Figure 5-86
Select speed dome connected channel.
There are two options: local/remote.
Please select remote type if you are connecting to the network PTZ.
Select the corresponding dome protocol such as PELCOD.
Set corresponding dome address. Default value is 1. Please note
your setup here shall comply with your dome address; otherwise
you cannot control the speed dome.
Select the dome baud rate. Default setup is 9600.
Default setup is 8. Please set according to the speed dome dial switch
217