Advertisement
4. Your program is now set, turn the wheel to the AUTO symbol to run your program.
5. You have a few options when the need arises to over-ride the program, without affecting your set program. For example, when leaving the house for a short
period to go shopping or a long period when on holiday.
a.Option 1: Boost Button.
b. Option 2: Holiday Mode
symbol to activate holiday mode. Set the date of your return from holiday using the +, - and OK buttons. The screen will then display
Turn the wheel to the
the number of days away on holiday and the
tion and will revert to normal at midnight on the morning of your return.
Wireless Configuration
Remember: the product comes pre-associated; the following information is if association is lost or configuration is restored to factory settings.
1. On the receiver, press and HOLD the button for 3 seconds, until the LED begins to flash slowly.
2. On the thermostat, turn the menu wheel to the
Press the R button and ensure that menu r-01 shows 0, press OK. Finally press the i button to initiate association. After a short time the screen should now
show rAd 1. Your product is now associated, confirm this by checking the LED on the receiver, which should now be off.
Additional Information: Receiver Button Functions
Reverse the relay contact (NO/NC)
Association Mode
Delete All Wireless Associations
When in AUTO mode, the screen will display the set temperature and either the
top right. This is the current program status, either ON (or comfort) or OFF (or setback). By pressing
the button in the top right, you switch between the two temperature-modes. This enables you to
either boost from OFF to ON or indeed reduce from ON to OFF, the addition of the hand next to
the symbol indicates that you have over-ridden. Note: the program will remain in the over-ride state
until you press the button again or until the end of that program.
to show that the mode is correctly configured. The program will maintain the temperature set for frost protec-
symbol. Press and hold the i button for 5 seconds to enter configuration mode.
=
Press and HOLD for 10 seconds (wait for audible click) / swap the grey and black wires.
=
Press and HOLD for 3 seconds (LED slow flashing)
=
Press and HOLD for 30 seconds (LED rapid flash & off)
or
in the
Advertisement
