Default Settings - eKey home series Operating Instructions Manual

Display
Status LED flashes green.
Status LED flashes red.
Status LED lights up red.
The lower status LED flashes red
briefly.
Link/activity LED off.
Link/activity LED flashing.
Link/activity LED on.
10/100 LED off.
10/100 LED on.
Table 2: Visual signals of ekey home CV LAN RS-485
4.6.3

Default settings

The LAN RS-485 converter comes with the following default settings.
ekey converter LAN RS-485
IP address
Network mask
Network gateway
Receiver port
Receiver IP address
Spacer
Protocol type
Communication type
Table 3: Default settings of ekey home CV LAN RS-485
Description
Normal mode.
The sent packets can be decrypted.
Incorrect connection.
The sent packets cannot be
decrypted.
Software error/update required.
Converter is starting/reset to default
settings was carried out.
No network connection.
Network activities.
Network connection enabled.
LAN speed 10 Mb.
LAN speed 100 Mb.
192.168.1.250
255.255.255.0
0.0.0.0
56000
0.0.0.0
_
rare
data transmission only
en│8