Configuring Data Packets - eKey home series Operating Instructions Manual

Step Instruction
5th After a few seconds, the configured ekey home converter LAN RS-485 appears in the
device list on the left.
The ekey home converter LAN RS-485 is accessible on the network and ready for data packet
configuration.
IP
169.254.224.99
IP address of the ekey
home CV LAN RS-485
Table 9: Description of the device list
7.3

Configuring data packets

You can use the configuration tool to configure data packets and set their parameters. The
following aspects must be set:
□ The receiver port;
□ The receiver IP address;
□ The spacer;
□ The protocol type;
Receiver port and receiver IP address
The receiver port and the receiver IP address define the receiver (data sink) uniquely on the
network.
The receiver port and the default transmitter port (56000) must be activated on the network. In
the router settings, make sure that the defined ports are also freely routed to the receiver.
Spacer and protocol type
The spacer and the protocol type define the composition of the data packet. The receiver must be
able to read and interpret the defined data packet.
Depending on the system you are using, there are three protocol types you can set.
See Protocol types, page 9.
Communication type
MAC
90 c6 B2 20 00 01
MAC address of the
ekey home CV LAN RS-
485
NOTICE
Serial#
802137-1315-0218
Serial number of the
ekey home CV LAN RS-
485
Version
3.2.15.18
Firmware version
en│19