Advertisement
41.
Secure Rafters to Top Wall Framing with one 3" screw per rafter. Screw through Wall Frame at
an angle. Have two helpers push the Front and Rear Walls at the top from the outside of shed until
inside to inside measurement between the Top Plates is 70".
42.
The Roof Gusset is positioned on center rafter. When correct, slide gusset up, use level to
square gusset and attach to rafter with 4 - 1 1/4" screws. Pilot hole Gusset to prevent splitting.
43.
Starting in front corner, locate 5/8" x 78" x 45 1/4" Plywood Roof Section and place on top of
Roof Rafters. Position so Plywood overhangs outside Rafter by 4". At bottom of Rafter, Roof Panel
should be flush with Rafter end.
1-888-658-1658
4" overhang
past Rafter.
Flush with end of
Rafter. Evenly
positioned on
Interior Rafter
www.outdoorlivingtoday.com
Page 19
sales@outdoorlivingtoday.com
Advertisement
