Connecting To The Lan Line; Network Environment Settings; Setting Procedure - Sanyo XG-705A Owner's Manual

4. Wired LAN Configurations
Setting procedures and contents differ depending on the LAN installation location.
When installing, consult your system administrator to set up the LAN appropriately.

Connecting to the LAN Line

Connect the LAN cable to the LAN connection terminal of the projector.

Network Environment Settings

Set the Wired LAN network through the projector menu.
Detailed network settings will be made with browser. Refer to "6. Configurations with
Browser" (pp.39–54).
First, complete the settings described in this chapter before performing steps in "6. Configurations
with Browser."

Setting Procedure

1. Turn on the projector and select "Wired" from the input menu of the projector.
The projector's Link Lamp will be on and the Access Lamp will start to blink. If the "Wired
setting" is "Off", it will not blink. Follow step 2 and 3 to blink the lamp.
2. Select "Wired Setting" in the projector menu, and press the SELECT button.
Select similar LAN environment among LAN1, 2 and 3 with the Point 7 8 buttons. (LAN1, 2,
and 3 are the factory default setting environments. You can select three different
environment among setting LAN1–3. For each setting, refer to the chart on page 31.)
When selecting "Off" in the "Wired setting", the LAN connection will be cut off. Use the
function when disconnecting the projector from the network.
3. Press the Point button then the "Please wait..." message will appear and switching operation
will start. Switching will take a while and after completing the operation, the "Ready for use"
message will appear. During the switching period, the projector cannot be operated.
26
LAN Connection Terminal
USB USB
Link Lamp (Orange)
Light orange when the
terminal is correctly
connected to the Network
HUB with the LAN cable.
Access Lamp (Green)
Blink green when
exchanging data with the
network.
* When the LAN setting is
"Off", the two lamps will
not be on.
LAN Cable