Input Source Selection (Component, Rgb Scart 21-Pin); Direct Operation; Menu Operation - Sanyo PLC-XU88 Owner's Manual

Input Source Selection (Component, RGB Scart 1-pin)

Direct Operation

Choose Computer 2 by pressing the INPUT button on the
top control or press the COMPUTER button on the remote
control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.

Menu Operation

1
Press the MENU button to display the On-Screen
Menu. Use the Point
frame pointer to the Input Menu icon.

Use the Point
▲▼
pointer to Computer 2 and then press the SELECT
button.

After the Source Select Menu appeared for Computer
2, move the pointer to Component or RGB(Scart) and
then press the SELECT button.
When the input source is coming from video
Component
equipment connected to the COMPUTER
IN 2/COMPONENT IN terminal with a
Component-VGA Cable, select Component.
When the input source is coming from video
RGB (Scart)
equipment connected to the COMPUTER
IN 2/COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
Note:
• Wired and Wireless are for the Network function. See
owner's manual "Network Set-up and Operation" .
• When the Input Search function is set to "On1" or "On2",
the input signal will be searched automatically (p.50).
• When Monitor out is selected in the Terminal function
(p.50), Computer 2 is not displayed.
0
buttons to move the red
◄►
buttons to move the red arrow
Top Control
INPUT button
Computer 1 (Analog)
Computer 1 (Digital)
Remote Control
COMPUTER button
Computer 1 (Analog)
Computer 1 (Digital)
Input Menu Input Menu icon
Computer

Source Select Menu
Move the pointer to
Component or RGB(Scart)
and press the SELECT
button.
Video Input
Computer 
Video
wired
wireless
Computer 
Move the pointer (red
arrow) to Computer 2
and press the SELECT
button.