Status Read Commands - Sanyo PLC HF10000L Owner's Manual

Appendix

Status Read Commands

Format
The command is sent from PC to the projector with
the format below;
"CR" [Command] [CR]
Command: one character (refer to the command
table below.)
The projector decodes the command and returns the
'Character string' with the format below;
Command
CR0
CR6
The tables on page 97 and 98 show the typical command lists for controlling the projector. Please consult your
local dealer for further information of other commands.
9
Return
Function
value
Status Read
Temperature Read %1 %2
Power On
00
Stand-by mode
80
Countdown
40
Cooling down
20
Power Malfunction
10
Cooling down at the temperature anomaly
28
Cooling down at Power Management mode
24
Power Management mode after Cooling down
04
Cooling down after the projector is turned off when the lamps
21
are out.
Stand-by mode after Cooling down when the lamps are out.
81
Stand-by mode after Cooling down at the temperature
88
anomaly.
Cooling down when the projector is turned off by the shutter
2C
management function.
Stand-by mode after Cooling down by the shutter
8C
management function.
%1 = Temperature at Sensor 1 (˚C)
%2 = Temperature at Sensor 2 (˚C)
(ex.) %1 = 12.3 (˚C), %2 = 23.4 (˚C)
--> The projector returns " 12.3 23.4" .
( For each sensor, two digit and the tenth place numbers are
displayed with a space between each temperature.)
Communication failure
?
Projector status