Table of Contents
Advertisement
Projector ID
This feature allows users to set serial communication
configuration (Projector ID) when several projectors are
connected via the RS-232C terminal (serial port) of the
projector.
Use the Point
buttons to adjust the Projector ID.
ed
Projector ID ... 1 - 999. (Factory default setting : Projector ID
Shutter
Shutter function is available to block out light to the screen,
so that the screen can be used for the other presenters.
Protection
Prohibits the shutter operation from the remote control and
the projector's side control.
Remote control . . . Selecting "On" prohibits the shutter
operation from the remote control.
Projector . . . . . . . . Selecting "On" prohibits the shutter
operation from the side control.
It is possible to prohibit the shutter operation from both of the
remote control and the side control.
Effect
Choose the image effect at opening or closing the shutter from
the following options.
Off ............. Disable.
L1 .............. The Image will fade in and out at opening or
closing the shutter.
L2 .............. The Image will fade in and out more slowly
compared with L1.
Release key
Choose the active buttons to release the shutter when the
shutter is closed from the following options.
Any ............ By pressing any buttons on the remoter control
and the side control when the shutter is closed,
the shutter will be released.
SHUTTER .. Only the SHUTTER button on the remote control
and the side control can be released the shutter
when the shutter is closed.
Only the following buttons are active when the
shutter is closed;
- INPUT button and INPUT 1/2/3/4 button
- ON/STAND-BY button
Management
The Shutter Management function turns off the projection lamp
when the projector is left with the shutter closed and the set
time has passed away. The count-down time can be set between
5 and 480 minutes. When the count-down time has elapsed,
the shutter will be opened up automatically and the lamp will be
turned off to cool itself down. The SHUTTER indicator is blinking
blue during this cooling-off period. When the lamp has been fully
cooled down, the POWER indicator turns green lighting and the
SHUTTER indicator keeps blinking. Should the ON / STAND-BY
button be pressed in this condition, the projection lamp will be
turned on and the SHUTTER indicator turns off.
1)
Settings
65
Advertisement
Table of Contents
