Operating With Projector Control - Sanyo PJLINK PLC-WM4500 Owner's Manual

Multimedia projector

Hide thumbs Also See for PJLINK PLC-WM4500:

Owner's manual (60 pages)

User manual (1 page)

Command list (1 page)

Table Of Contents

Table of Contents

Lens Operation

The following lens operation can be made with the Lens button on

the side control.

Press the LENS button to enter each lens operation mode. The

selected adjustment display appears on the screen.

Zoom " Focus " Lens Shift "

Zoom Adjustment

Display Zoom on the screen. Use the Point pq buttons to

zoom in and out the image.

Focus Adjustment

Display Focus on the screen. Use the Point pq buttons to

adjust focus of the image.

Lens Shift Adjustment

Display Lens shift on the screen. Use the Point pqt u

buttons to position the screen to the desired point without having

picture distortion.

The screen can be moved up or down to 60 percent, or sideways

up to 10 percent from the central axis of the lens shift.

Press and hold the LENS button on the side control or the LENS

SHIFT button on the remote control for 5 seconds or more to

return the lens to the center position, after that the four white

arrows on the screen turn to red.

Note:

• The arrow disappears at the maximum lens shift in each

direction.

• The arrow turns red when the lens shift comes to the

center position of the screen.

INFO . button

Information display can be used to confirm the current operating

condition of the projector and the signal being projected through

the projector.

Press the INFO. button on the remote control to display the

information window on the screen. To hide the information

window, press the INFO. button again or press the MENU button.

The information window can also be selected from the

menu.

Note:

• The H-sync freq. and V-sync freq. values described in the

figure may be different from the actual values.

• SERIAL NO. is used to service the projector.