Remote Control Battery Installation; Remote Control Receivers And Operating Range; Wired Remote Control Transmitter - Sanyo PJLINK PLC-WM4500 Owner's Manual

Multimedia projector
Hide thumbs Also See for PJLINK PLC-WM4500:
Table of Contents

Advertisement

Open the battery
1
compartment lid.
Press the lid downward and
slide it.
To ensure safe operation, please observe the following precautions :
ü
ü
ü
ü
ü
ü
ü
ü
ü

Remote Control Receivers and Operating Range

Point the remote control toward the projector (to Infrared Remote
Receivers) when pressing the buttons. Maximum operating range
for the remote control is about 16.4' (5 m) and 60 degrees in front,
back and top of the projector.
Infrared Remote Receivers are provided in front, back and top of of
the projector. You can conveniently use all of the receivers (pp. 10,
11, 59).
P
Note:
When hanging the projector from the ceiling, select the Infrared
Remote Receiver which is located farther away from the fluorescent
light (p.59).
The remote control can be used as a wired remote control. Wired
remote control helps you use the remote control outside of the
operating range (16.4'/ 5 m). Connect the remote control and the
projector with the remote control cable (sold separately). Connected
with the remote control cable, the remote control does not emit
wireless signal.

Remote Control Battery Installation

Install new batteries into

the compartment.
Use two (2) AAA or LR03 type alkaline batteries.
Always replace batteries in sets.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not expose the remote control to moisture or heat.
Do not drop the remote control.
If the battery has leaked on the remote control, carefully wipe the case clean and install new
batteries.
Risk of an explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Wired Remote Control Transmitter

Part Names and Functions
Replace the

compartment lid.
Two AAA size batteries
For correct polarity (+ and
–), be sure battery terminals
are in contact with pins in the
compartment.
16.4'
(5 m)
16.4'
(5 m)
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Plc-wm4500/l - 4500 lumensPlc-wm500lPlc-wm4500l

Table of Contents