Hydrostatic Transmission - Titan TTK550LWM Owner's Manual

TTK550LWM by TITAN
GB
IE
Moving without mowing
It has to be used (as indicated by the highway code) in private areas closed to
traffic.
NOTE
cutting deck put at its highest position.
Mechanical transmission
Put the accelerator control between the «SLOW» and «FAST» positions and the gear
change lever in the 1st speed position.
Keep the pedal pressed down and disengage the parking brake. Slowly release the pedal
which will turn from «brake» to «clutch», thus operating the rear wheels.
The pedal has to be released gradually as a sudden engagement may cause tipping up
and loss of control of the vehicle.
Gradually reach the desired operating speed using the accelerator and gear lever. To
change the gear speed the clutch must be used pushing the pedal down half way.

Hydrostatic transmission

Put the accelerator control between the «SLOW» and «FAST» positions. Press the
brake pedal to disengage the parking brake and release the pedal.
Press the drive pedal (
progressively increasing pressure on the pedal and moving the accelerator.
Braking
Mechanical transmission
To brake, first reduce the speed on the accelerator to avoid overloading the brake
assembly and then push the pedal down fully.
Hydrostatic transmission
First reduce the machine's speed by reducing the engine's rpm, and then press
the brake pedal to slow down the machine until it stops.
The machine already slows down considerably by just releasing the drive pedal.
5.4.4 Reverse
Mechanical transmission
The machine MUST be stopped before reverse can be en ga ged. Push down the pedal
until the machine stops and then insert reverse by moving the lever sideways and putting
it into position «R». Gradually release the pedal to en ga ge the clutch and then begin
moving in reverse.
28
The machine has not been approved for use on public roads.
When moving the machine, the blade must be disengaged and the
22.) in direction «F» and reach the required speed by
Operation